Oil is an indispensable partner in driving the car and is one of the most important energy sources. Therefore, this resulted in the product of a refueling vehicle. What details should be taken into account when operating a refuelling vehicle?

1. Refueling vehicles are prohibited from refueling near high-voltage power lines and other hazardous locations.

2. It is prohibited to pour gasoline into the carburetor port when the refueling engine is running or when it is cranking. Some driver friends add gasoline to the carburetor in order to increase the concentration of the air-fuel mixture in the cylinder. This will be helpful if the oil fails to enter the cylinder. This may also cause backfire, burns, burned vehicles, etc. harm.

3. Fuel dispensers do not promote petrol filter cartridges when maintaining gasoline filters. Some of the driver's friends like to use gas-fired ceramic filter to remove impurities from the filter when they are maintaining the fuel filter. Doing so can easily cause a fire and at the same time affect the service life of the filter element.

4. In the oil depot, the fuel tanker must not use the short-circuit method to check the storage condition of the battery. In well-ventilated small oil depots, equipment such as tires, batteries, and tarpaulins are often placed on the floor, and there is also spilled gasoline on the ground. The sparks generated during the fire fighting are likely to ignite the oil molecules in the air.

5. The drag chain of the refueling vehicle must not be wrapped around the girder. Oil, like other substances, also generates static electricity when rubbed against another object. This kind of electrostatic flashover may ignite the fuel and cause a fire. Therefore, a grounded grounding wire should be installed on the oil depot, and a grounded iron chain should be installed on the refuelling tank to prevent electrostatic sparks in the tank. This chain cannot be wound on the frame of the beam and must be placed on the ground. On, and drag the lot no less than 50 centimeters.

6. It is strictly forbidden to use the hanging fire method. Sometimes car spark plugs will have carbon deposits. When a certain cylinder's carbon deposition is serious, the cylinder can't work normally. In order to make the cylinder work normally, use the method of “ hanging fire ” outside the cylinder ( leaving the spark plug and the high voltage wire 3 (mm -4 mm clearance ) to increase the energy of spark plug electrode flashover to make the cylinder work, but the general " hanging fire " method is easy to fall off with little attention. If there is dripping gasoline on the cylinder, it is extremely easy to have a fire. Therefore it is only a temporary remedy. Correct treatment should be timely cleaning and maintenance of spark plugs, try to avoid the use of " hanging fire " method.

7. It is forbidden to have drip in the automobile oil system. If there is a drip in the fuel tank part of the refuelling vehicle, and it is encountering a late ignition point and a mixed gas lean point, the exhaust pipe will ignite due to slow combustion, and the temperature of the vehicle body will rise, exceeding 10 times the ignition point of gasoline vapor ( gasoline The ignition temperature of the vapor is 28 °C ) . Leaking out the oil can easily cause a fire and cause the vehicle to be scrapped. If the carburetor part drips on the cylinder head, spark plug high voltage spark leakage may also cause fire.

The driver needs to have a strong sense of responsibility to operate the refueling vehicle. Do not be miserable because of his own negligence. Start from the self, protect yourself and protect others!

Computer Control Hydraulic Compression Testing Machine

Concrete Compressive Strength Testing Machine,Pressure Testing Machine,Concrete Sleeper Static Load Tester,Elastic Modulus Testing Machine

Jinan Chenda Testing Machine Manufacturing Co., Ltd. , https://www.jncdtester.com