1. Before each time the material inlet is opened, the pressure relief valve and the inlet valve must be opened. After the remaining gas in the tank is removed, the lid is opened to avoid injury. 2, always pay attention to whether the pressure gauge is working properly, prevent the failure of the pressure gauge, overpressure, and the explosion of the tank exploded. 3, often check the safety valve, to ensure pressure relief at 0.2Mpa, the tank body pressure shall not exceed 0.2Mpa. 4, often check the operating table is working properly, so as to avoid over-rotation and damage to the air compressor and power take off (specifically refers to the powder tank bicycle). 5. Always listen to the sound of the PTO and air compressor. If there is abnormal sound, stop the machine immediately to eliminate the malfunction. Machining Plastic has a small density, light weight, can be insulated. machining Plastic is the use of CNC machining out, including drilling. Cutting, turning, machining Plastic commonly used products are: PA PC, Tetlon POM, PMMA. , we have a special inspection room to test the products, to ensure that and each size in line with the requirements of the drawings, but also a special machine for the production of material to withstand voltage insulation test. Applied in a variety of industries, including: drone, ship, communications, medical equipment, industrial automation equipment. Machining Plastic,Oem Precision Machining Plastic,Cnc Machining Plastic,CNC Plastic Machining Hong Kong RYH CO., LTD , https://www.bldcncmachining.com