HSK ER Collet Chuck Lathe Tool Holder,Mechanical spindle and cutting tools and other accessories.High Precision HSK shank Tool Holder ,balanced G6.3 or G2.5 For choose,With DIN6499 collet chuck can be straight shank cutter clamping various sizes.We are specializing in the production of HSK ER Spring Collet Chuck, we can to figure to sample processing, and perfect after-sales service and technical support. Looking forward to your cooperation!
Hsk Collet Chuck,Cnc Hsk Er Tool Holder,Hsk Er Spring Collet Chuck,Hsk Er Collet Chuck JINING QINFENG MACHINERY HARDWARE CO.,LTD , https://www.qftoolholder.com
2.Place the socket that matches the guard bolts onto the 3/8-inch drive ratchet and loosen the nuts that hold the guard onto the top of the roll-forming machine.
3.Lift the guard up to remove it from the top of the roll former.
4.Blow out the area between the rolls with the air hose to remove metal shavings and other debris from the series of rolls, and spray the rolls with tool oil to add lubrication and prevent corrosion from forming on the face of the rolls.
5.Slide the guard back over the studs and tighten the nuts with the ratchet to secure the guard to the roll-forming machine.
6.Inspect the installed guard to ensure that no part of the guard falls into the feed area of the roll-forming machine and that the starting guide located on the feeder bed, in front of the guard, is not damaged.
7.Turn on the roll-forming machine by depressing the green start button.
8.Rest the side of the metal that is going to be roll formed against the starting guide and slide the metal toward the guide.
9.Support the metal sheet as it is grabbed by the roll-forming machine, works its way down through the series of rolls and is ejected from the far side of the roll-forming machine.
10.Inspect the finished rolled edge to ensure that the clearances are correct. If you notice that the seam is malformed or jammed tight, adjust the rolls according to the operating manual and run another piece of sheet metal through the roll-forming machine.
How to use a roll forming machine?--YuFa roll forming
1.Put on your safety glasses.